,

NETIS P110C 8POE+2RJ45 100M Standard POE Switch


Hardware
Interface 8*10/100Mbps POE ports(Data/Power)

2*10/100M uplink RJ45 ports (Data)

 Basic function  Follow IEEE 802.3 Ethernet and IEEE802.3u Fast Ethernet Protocol

Supports POE IEEE 802. 3af/at compliant Powered Device (PD)

Store-and-forward switching scheme
Support IEEE802.3X full duplex and Backpressure half duplex
MAC address auto-learning & auto-aging

 Standards  IEEE 802.3 10BASE-T Ethernet

IEEE 802.3i 10BASE-T Ethernet

IEEE 802.3u 100BASE-TX Fast Ethernet
IEEE 802.3af/at, Power over Ethernet
IEEE 802.3x Flow Control

 Mode  Normal switch mode/Extend mode
 Data Transfer Rate Etherent:10Mbps(Half-duplex);20Mbps(Full-duplex)

Fast Entherent:100Mbps(Half-duplex);200Mbps(Full-duplex)

 Store & Forwarding Yes
 Switching Capacity 2G
 MAC Address

Table Size

2K
 Jumbo Frame  2048 byte
 Environment  Operation Temperature:0℃~40℃

Storage Temperature:-40℃~70℃

Operation Humidity:10%~90% RH Non-condensing

Storage Humidity:5%~90% RH Non-condensing

 Power Input POE

Standards

 Single port maximum power 30W,

Whole switch maximum power 120W

Support over-current,over-voltage and short-circuit protection

Support Soft Start of High  Power PD

Support sequential boot-up

Power Supply Pin:12+/36-

100-240V 2A Max(Input)

52V 2.3A Max(Output)

 Cabling type  100Base-TX: Cat 5e or better UTP/STP(≤100m)

10Base-TX: Cat 5e or better UTP/STP(≤250m)

Dimensions

(L x W x H )

 190mm*140mm*43mm

৳ 5,300.00

Compare

Netis P110C is a 100M standard POE switch that provides 10 10/100M adaptive RJ45 ports. Ports 1~8 features POE power supply capability and can be used as Power over Ethernet devices. The power supply port can automatically detect and recognize the powered device that complies with the IEEE 802.3af/at standard and supply power through the network cable.Supports two modes: normal switch mode/250M ultra-long transmission. P110C makes it easier for you to deploy wireless access point (AP) and IP terminal network devices using POE technology.

 

  • Supporting 802.3 Ethernet, 802.u Faster Ethernet;
  • Supports POE IEEE 802.3af/at compliant Powered Device (PD);
  • Modes: Normal switch mode/Extended mode(Port1-4:250Metres ultra-long
  • transmission);
  • Ports 1~8 features POE power supply capability and can be used as Power over
  • Ethernet devices;
  • Auto MDI/MDIX crossover for all ports;
  • Support full duplex based on IEEE802.3x and half duplex based on Backpressure;
  • Support non-blocking wire speed forwarding;
  • MAC address auto-learning & auto-aging;
  • Steel case,the total POE power budget of 120W;
  • Just Plug and Play.

 

Categories: ,

Based on 0 reviews

0.0 overall
0
0
0
0
0

Be the first to review “NETIS P110C 8POE+2RJ45 100M Standard POE Switch”

There are no reviews yet.